ABA blown film machineSteps need to pay attention to driving
ABA blown film machine using normal driving steps, due to the difference between model may be a part in slightly different, but usually do to pay attention to the following instructions:Dalian blown film machineFactory summarized for you:
1, start,Air compressor, storage cylinder pressure is 6-8 kg/cm stop. Set aside.
2, such as for a long time after the stop driving, each point still need constant temperature after heating temperature of target ranges 10 to 30 minutes, such as parking and a half hours to drive, do not need constant temperature.
3, check all film thickness, width, and adjust, make it meet the requirements.
4, according to the film diameter, thickness and extruder production ability request, estimate the traction speed and steady bubble diameter.
5, heating extruder body, head, die head, control temperature at various points within the index.
After 6, each point temperature of indicators meet the requirements, wear labor insurance supplies, in order to start the tractor, blower, extruder.
7, die discharging uniform, can wear gloves slowly lift pipe, pipe end will be closed at the same time, the micro into gas regulator, from central hole of the plug into a small amount of compressed air, and then carefully stiff foam frame, plates, and wear into the traction roller, guide roller and coiling.
